Fog lamp housing, removing and installing
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
Audi A4:
Fig 1: Releasing Catches Using Screwdriver And Removing Air Intake Grille On Left/Right On Bottom Part Of Bumper
- Release retaining hooks - 1... 4 - using a screwdriver - arrow - and pull off air intake grille in bottom section of bumper.
Audi S4:
- Turn screw - 1 - 90 ° (1/4 turn).
- Remove air intake grille from fog lamp housing in direction of - arrow A -.
- Then push air intake grille in direction of - arrow B - and simultaneously disengage retaining clip - 2 -.
- Remove air intake grille.
All models:
- Remove screws - arrows -.
- Disengage fog lamp housing and remove.
- Disconnect electrical connection.
Installing
Install in reverse order of removal, noting the following:
- Engage fog lamp housing.
- Check and adjust fog lamps if necessary → 00 - TECHNICAL DATA .
Tightening torque
| Component - fastener | Nm |
| Fog lamp housing to bumper - screw | 5 |