Fog lamp housing - Audi RS4, removing and installing

Removing 

• Turn light switch to position "0".

Removing 

Fig 1: Pulling Off Air Inlet Grille In Lower Section Of Bumper Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Pull off air inlet grille in lower section of bumper cover - arrows  -.

Fig 2: Identifying Screws For Fog Lamp Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove screws - arrows  -.
• Disengage housing and remove from opening.
• Disconnect electrical connection.

Installing 

Install in reverse order of removal, noting the following:

• First engage fog lamp housing on inner side of bumper cover.
• Check and adjust fog lamps if necessary → 00 - TECHNICAL DATA .

Tightening torques