Rear window wiper motor, removing and installing

Removing 

• Remove wiper arm → Rear window wiper arm, removing and installing .
• Remove lower rear lid trim → 70 - INTERIOR TRIM .

Fig 1: Identifying Electrical Connection, Washer Fluid Hose, And Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect electrical connection - 2  -.
• Disconnect washer fluid hose - 1  - from connecting pipe for spray jet.
• Loosen nuts - arrows  - and detach wiper motor.

Installing 

Install in reverse order of removal, noting the following:

• Carefully insert rubber grommet into hole in rear window.

• Fluid hose must audibly engage in spray jet connection.

• Switch on ignition.
• Actuate rear wiper and allow wiper motor to move to end position.

• Install lower rear lid trim → 70 - INTERIOR TRIM .
• Adjust wiper arm → Rear window wiper arm park position, adjusting .