Ribbed belt, component overview
NOTE:
- Before removing ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt under operating conditions. When installing, make sure the belt is correctly seated in the belt pulley.
1 - Ribbed belt
- Ribbed belt routing → Ribbed belt, routing
- Check for wear
- Do not kink
- Removing and installing → Ribbed belt, removing and installing
2 - Pulley
- For ribbed belt
- Removing and installing → Crankshaft belt pulley, removing and installing
3 - Special bolt
- Replace
- Torque specification 10 Nm plus an additional 90 °
4 - 23 Nm
5 - Engine lift eye
6 - Belt tensioner for ribbed belt
- To release tension on ribbed belt, pivot using open-end wrench.
- Secure tensioner with special tool Locking Tool T40098
7 - 23 Nm
8 - Bushing
9 - Bracket for assemblies
- Removing and installing → Accessory assembly bracket, removing and installing
10 - 23 Nm
11 - Generator
- Removing and installing → 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- To facilitate installing the generator, slightly drive back threaded bushings for retaining bolts on generator.
12 - 23 Nm
13 - Power steering pump
- Removing and installing → 48 - STEERING
14 - 45 Nm
- Insert with locking fluid
- Locking fluid
- Observe tightening sequence → Accessory assembly bracket, removing and installing
15 - Bushing
- 2 pieces
16 - Air conditioner compressor
- Removing and installing → 87 AIR CONDITIONING
17 - 25 Nm
18 - Idler roller for ribbed belt
- Note installation position
19 - 20 Nm plus an additional 90 ° (1 /4 turn)
- Replace