LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2007 >> A4 Base, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 2.0L - Turbo Engine Mechanical, Engine Code(S): BPG, BWT >> 13 - Engine - Crankshaft, Cylinder Block >> Crankshaft, removing and installing >> Crankshaft, removing and installing >> Sensor wheel, removing and installing

Sensor wheel, removing and installing

Fig 1: Identifying Attachment Points, Countersunk Screws, Crankshaft & Sensor Wheel
GW00000317Courtesy of VOLKSWAGEN UNITED STATES, INC.
NOTE:
  • After tightening a second time, the attachment point of the countersunk screws of the sensor wheel are so deformed that the screw heads lie on the crankshaft - 3  - - arrows  - and the sensor wheel is loose underneath the screws.
  • Installation of sensor wheel is only possible in one position - the bores are offset.

Torque specifications 

Component   Nm
Sensor wheel to crankshaft   10 + 90 ° 1)2)
  • 1) Replace screw
  • 2) 90 °Corresponds to a 1/4 turn
scientia non olet · About LEMON Manuals