Vehicle Electrical System Control Module J519 , removing and installing
NOTE:
- Should Vehicle Electrical System Control Module J519 require replacement, follow replacement procedures as specified using VAS 5051/5052 in mode "Guided Fault Finding".
Removing
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Where applicable, remove drivers storage compartment → 68 - INTERIOR EQUIPMENT .
- Remove nuts - arrows - and remove Vehicle Electrical System Control Module J519 - 1 -.
- Unclip fuse carriers - 1... 3 -.
- Release retaining clip at connector - 4 - and disconnect connector.
- Disconnect electrical connections - 5 - and - 6 -.
Installing
Install in reverse order of removal, noting the following:
- Install drivers storage compartment → 68 - INTERIOR EQUIPMENT .
Tightening torque
| Component - fastener | Nm |
| Control module to central tube for instrument panel - nut | 2.4 |