Steering Angle Sensor G85 , removing and installing
NOTE:
- Should the Steering Angle Sensor G85 require replacement, follow applicable component "Replacement" as well as "zero - calibrate" procedure using VAS 5051/5051 in operating mode "Guided Fault Finding".
Removing
- Remove spiral spring → Spiral spring, removing and installing .
Fig 1: Removing Steering Angle Sensor G85 From Steering Column Electronic Systems Control Module J527
- Remove Steering Angle Sensor G85 - 1 - from Steering Column Electronic Systems Control Module J527 in direction of - arrow -.
Installing
Install in reverse order of removal, noting the following:
- Perform "zero - calibrate" procedure using VAS 505/5052 in operating mode "Guided Fault Finding".