High Beam Headlamp M30 / M32 - bulb, replacing
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
Left headlamp
- Remove left engine cover - 1 -.
- Disconnect electrical connectors - 1 - and - 2 - from retainer.
- Unclip retainer for connectors and pull off upwards - arrow -.
Additional preparation:
Right headlamp - vehicles with 1.8L 4-cylinder Turbo engine:
- Remove air cleaner housing.
Right headlamp - vehicles with 3.0L 6-cylinder engine:
- Remove air cleaner housing.
Right headlamp - vehicles with 4.2L 8-cylinder petrol engine:
- Remove air cleaner housing.
Both sides, continued:
- Release retaining clip - arrow - and detach housing cover for high beam from headlamp housing.
- Disconnect electrical connection - 3 - at high beam headlamp bulb.
- Release retaining clip - 2 - and remove bulb - 1 - from housing.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.
- Fit new bulb in housing.
- Secure bulb with retaining clip.
- Secure housing cover with retaining clip.