Windshield wiper blade park position, adjusting
Procedure
- Switch on ignition.
- Actuate touch-wipe function and allow wiper motor to move to end position.
- Switch off ignition.
- Position wiper blades on windshield and align as follows:
- Dimension - a - = 24 mm.
- Dimension - b - = 44 mm.
NOTE:
- The figures given here are the distances between wiper blades and cowl panel grille of plenum chamber at bottom edge of windshield.
- Tighten nuts for wiper arms.
- Switch on ignition.
- Actuate touch-wipe function and allow wiper motor to move to end position.
- Switch off ignition.
- If necessary, re-align wiper arms and tighten nuts again.
Tightening torque
| Component - fastener | Nm |
| Wiper arm - nut | 21 |