Fastener Tightening Specifications
| Components |
Fastener Size |
Nm |
| All Wheel Drive Control Module to Rear Final Drive |
- |
6 |
| Buffer to Rear Final Drive1 |
- |
60 + 90° |
| Cover for Oil Filter |
- |
35 |
| Crossmember to Underbody |
- |
23 |
| Drain Plug for Haldex Clutch Pump |
- |
30 |
| Driveshaft to the Bevel Box |
- |
60 |
| Flange to Driveshaft, Nut |
- |
210 |
| Flange to Rear Driveshaft Tube |
- |
45 |
| Flexible Disc with a Heat Shield to Front Driveshaft Tube1 |
- |
50 + 90° |
| Flexible Disc with a Heat Shield to Manual Transmission with Bevel Box |
- |
60 |
| Flexible Disc with Vibration Damper to Rear Driveshaft Tube |
| -Balance Nut |
- |
10 |
| -Bolt1 |
- |
50 + 90° |
| Flexible Disc with Vibration Damper to Rear Final Drive |
- |
60 |
| Front Flexible Disc1 |
- |
50 + 90° |
| Haldex Clutch Housing |
- |
50 |
| Haldex Clutch Pump to Haldex Clutch Housing |
- |
6 |
| Haldex Clutch to Rear Final Drive |
- |
50 |
| Intermediate Bearing Heat Shield |
- |
25 |
| Lock Plate to CV Joint Protective Boot |
- |
40 |
| Manual Transmission with Bevel Gear Transfer Case1 |
- |
50 + 90° |
| Oil Filler Plug |
M10 x 1 |
15 |
| Oil Filler Plug |
M20 x 1 |
40 |
|
|
-- Tighten pendulum support first to transmission -arrows B and C- and then to subframe -arrow A-.
Courtesy of AUDI OF AMERICA, LLC
| Component |
|
Nm |
| On the pendulum support |
Transmission -arrows B and C- |
40 Nm + 90° 1) |
| |
Subframe -arrow A- |
100 Nm + 90° 1) |
| 1)
Replace Bolts |
-- Tighten the pendulum support with new bolts. For the correct tightening specifications refer to Specifications
.
Courtesy of AUDI OF AMERICA, LLC
| Component |
|
Nm |
| On the pendulum support |
Transmission - 1 - |
40 Nm + 90° 1) |
| |
Transmission - 2 - |
40 Nm + 90° 1) |
| 1)
Replace Bolts |