HALDEX-Clutch (Generation HALDEX IV), Rear Final Drive 0BR, 0BS And 0BY Overview
- Seal
- Always replace
- Coat with high performance Haldex clutch oil and insert
- Haldex Clutch Housing
- Haldex clutch, removing and installing, refer to HALDEX CLUTCH OVERVIEW
- All Wheel Drive (AWD) Control Module -J492-
- With Haldex clutch control valve -N373-
- Removing and installing, refer to AWD Control Module -J492-, REAR FINAL DRIVE 0BR, 0BS AND 0BY (HALDEX-CLUTCH GENERATION IV)
- Bolts
- 6 Nm
- Flange/Driveshaft Sealing Ring
Removing and installing, refer to REAR FINAL DRIVE FLANGE/DRIVESHAFT SEAL, FINAL DRIVE INSTALLED
- Driveshaft Flange
- Removing and Installing, refer to REAR FINAL DRIVE FLANGE/DRIVESHAFT SEAL, FINAL DRIVE INSTALLED
- Nut
- 210 Nm
- Secure with locking fluid D 000 600
- Bolts
- 50 Nm
- Quantity: 4
- Cover
- For the oil filter housing
- A filter change is not required
- Cover
- For the pressure reservoirWARNING:
Never open the cover, danger of injury!
- For the pressure reservoir
- Seal
- Always replace
- Quantity: 2
- Diameter 34 mm
- For Haldex clutch pump -V181-
- Coat with high performance Haldex clutch oil and insert
- Haldex Clutch Pump -V181-
- Removing and Installing, refer to Haldex Clutch Pump -V181-, FINAL DRIVE 0BR/0BS/0BY
- Bolts
- 6 Nm