Oil Level In The HALDEX Clutch, Checking
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Torque Wrench 5-50 Nm V.A.G 1331
- Drip Tray for VAS 6100 VAS 6208
Test Prerequisites
- The oil temperature must be between 20 °C and 40 °C (68 °F and 104 °F).
- The oil temperature can be reached by driving the vehicle for awhile.
- The vehicle must be horizontal.
- Final drive must be in installation position to check oil level.
To prevent possible injury when performing measuring tests or test drives, always refer to SAFETY PRECAUTIONS .
-- Connect the vehicle diagnosis tester with the ignition on the Data Link connector (DLC) turned off.
Installed location: Front left footwell, near hood opener.
Enter "Guided Fault Finding" :
-- Turn on the ignition.
-- Touch "Guided Fault Finding" on the screen.
-- Select the following in this sequence:
- Brand
- Type
- Model year
- Version
- Engine code
- Confirm the information entered.
- 22 - AWD electronics
- 22 - Read the measured values block
- Oil temperature
-- Read the oil temperature.
Vehicles with Crossmembers:
-- Cover the crossmember -arrows- with cloths.
If oil gets on the crossmember or enters the perforations in the crossmember, it must be carefully removed.
Oil Level, Checking
-- Place VAS 6208 under final drive.
-- Remove oil level inspection plug -arrow-. (Shown with final drive removed for the sake of clarity).
Oil level is correct if Haldex clutch is filled to lower edge of oil filler hole or up to 3 mm below oil filler hole.
-- If necessary, fill high performance Haldex clutch oil, refer to HALDEX CLUTCH OIL, FILLING
Tightening Specifications
| Component | Nm |
|---|---|
| Oil filler plug -arrow- | 15 |