Exhaust System, Aligning

• Align exhaust system when cold.

• For the correct tightening specifications, refer to EXHAUST SYSTEM OVERVIEW .

-- Loosen front double clamping bolts  EXHAUST SYSTEM OVERVIEW.

-- Push exhaust system far enough forward so tension at the retaining loop at rear muffler is a = 5 to 11 mm.

-- Install clamping sleeve so that the end of the bolt does not extend beyond the lower edge of the clamping sleeve.

• Threaded connection points toward the right.

-- Tighten clamping sleeve threaded connections evenly.

Aligning Tailpipe:

-- Align the tailpipes so the distance -a- is the same on the left and right.

-- At the same time, the clearance -b- from the bumper cut-out to the tailpipes must be achieved.

• Dimension b = at least 22 mm

-- If necessary, loosen the suspended mountings of the rear muffler to align the tailpipes.