HALDEX-Clutch (Generation HALDEX IV), Rear Final Drive 0BR, 0BS And 0BY, Checking Functions
Identification on Rear Final Drives "0BR" and "0BY"
The ID -arrow- on the bottom side of the final drive identifies which final drive is installed.
The Haldex clutch test is performed during a road test with the vehicle diagnosis tester.
Rear Final Drive Designation "0BS"
To prevent possible injury when performing measuring tests or test drives, always refer to SAFETY PRECAUTIONS .
-- Connect the vehicle diagnosis tester with the ignition on the Data Link Connector (DLC) turned off.
Installed location: Front left footwell, near hood opener.
Enter "Guided Fault Finding" :
-- Turn on the ignition.
-- Touch "Guided Fault Finding" on the screen.
-- Select the following in this sequence:
- Brand
- Type
- Model year
- Version
- Engine code
- Confirm the information entered.
- 22 - AWD electronics
- 22 - Output Diagnostic Test Mode
-- Start the output diagnostic test mode and follow the instructions on the tester.