Electric And Electronic Components And Installation Locations, Rear Final Drive 02D/0AV (HALDEX-Clutch Generation II)
- All Wheel Drive (AWD) Control Module -J492-
- Installed location, refer to Fig 2
- Comprises a unit together with Haldex clutch control valve -N373-
- A pressure sensor is also located in the control module
- Removing and installing, refer to All Wheel Drive Control Module -J492-, REAR FINAL DRIVE 02D/0AV (HALDEX-CLUTCH GENERATION II) OVERVIEW
- Important signals are transmitted from the engine control module and ABS control module -J104- via data BUS to the AWD control module --.
- Haldex Clutch Pump -V181-
- Installed location, refer to Fig 3
- Can be checked in "Guided Fault Finding" using the vehicle tester
- Removing and Installing, refer to Haldex Clutch Pump -V181-, FINAL DRIVE 02D/0AV
- Data Link Connector (DLC)
- Installed location: Front left footwell, near hood opener
- Parking Brake Indicator Lamp Switch -F9-
- Installed location, refer to Fig 5
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester
- Removing and installing, refer to [For engine(s) CBRA, BPY, CCTA, CBFA] Removal and Installation
- Brake Lamp Switch -F-
- Installed location, refer to Fig 4
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester
- Removing and installing, refer to [For engine(s) CBRA, BPY, CCTA, CBFA] Removal and Installation
Installed location: The control module -A- is located at the rear final drive in the front left area.
Installed location: The Haldex clutch pump -arrow- is located on the rear final drive in the front right area.
Installed location: Brake lamp switch is located on pedal assembly over brake pedal.
Removing, refer to [For engine(s) CBRA, BPY, CCTA, CBFA] Removal and Installation
Installed location: The switch -arrow- is installed on the parking brake lever.
Removing, refer to [For engine(s) CBRA, BPY, CCTA, CBFA] Removal and Installation