Battery, reconnecting (all)
NOTE:
- In order to prevent damage to the battery housing, battery terminals must be placed on battery posts without using force (by hand only).
- Battery posts and terminals must no longer be greased.
- Reconnect negative ( - ) terminal -arrow- on battery.
- Torque negative ( - ) terminal clamp fastener to 6 Nm.
- Perform work steps specified in table. Refer to Battery, disconnecting and reconnecting .
Work steps required after reconnecting battery
| Work steps | completed? |
| Diagnostic Trouble Code (DTC) Memory: Check using VAS 5051/5052 in mode "Guided Fault Finding". |
|
| Power windows (where applicable): Completely open and close all power windows. |
|
| Radio: Input anti-theft radio code and check radio, CD & tape player functions as applicable. |
|
| Clock: Check and reset to local time. |
|
| All electrical consumers: Check function. |
NOTE:
If desired, print this section and use the table above as a checklist.