Low Beam Headlamp M29 / M31 - bulb, replacing

Removing 

• Turn light switch to position "0".

Fig 1: Evaporative Emission Canister Purge Regulator Valve N80 And Air Duct

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove screws - arrows  -.
• Remove Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 N80 - 1  - at air duct.
• Remove air duct - 2  -.

Fig 2: Locating Retaining Tab

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Release retaining tab - arrow  - and detach housing cover from headlamp housing.

Fig 3: Identifying Bulb, Spring Clips, And Electrical Connection

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bulb - 2  - from spring clips - arrows  -.
• Disconnect electrical connection - 1  - at low beam bulb.

Installing 

Install in reverse order of removal, noting the following:

• Insert bulb into housing.
• Position bulb at lower spring clip.
• Push bulb beyond resistance of upper spring clips into housing.
• Reconnect electrical connection and close housing cover.