Daytime Running Lamp (DRL) bulb, replacing
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
Right headlamp
- Remove screws - arrows -.
- Remove air ducts - 1 - and - 2 -.
Both sides, continued:
- Release retaining tab - arrow - and detach housing cover for side lights from headlamp housing.
- Turn bulb holder - 1 - counter-clockwise - arrow - and remove from headlamp housing.
- Screw bulb out of bulb holder.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.
- Fit new bulb in housing.
- Secure bulb holder by turning clockwise.
- Close housing cover.