Fog lamp housing - Audi A4, removing and installing
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
Vehicles without charge air cooler:
- Release fasteners - 1 - and - 2 - and remove front noise insulation.
Vehicles with charge air cooler:
- Remove front bumper cover → 63 BUMPER .
All models:
- Remove screws - arrows -.
- Disconnect electrical connection - 2 -.
- Remove fog lamp housing - 1 -.
Installing
Install in reverse order of removal, noting the following:
Vehicles with charge air cooler:
- Install front bumper cover → 63 BUMPER .
All models:
- Check and adjust fog lamps if necessary → 00 - TECHNICAL DATA .
Tightening torque
| Component - fastener | Nm |
| Fog lamp housing to bumper cover - screw | 6 |