Removing cover and cushion from seat pan

Fig 1: Removing Cover And Cushion From Seat Pan

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Cover and padding

• Removing 

• Remove seat → Seat, assembly overview .
• Attach fixture for seat repair VAS 6136 to engine and transmission holder VAS 6095.
• Attach front seat to fixture for seat repair VAS 6136.
• Remove storage compartment → Storage compartment, removing and installing .

• Remove backrest adjuster → Backrest adjuster, removing and installing .
• Remove seat height adjuster → Seat height adjuster, removing and installing .
• Remove side trim on outboard side → Side trim on sill panel side, removing and installing .
• Remove side trim on inboard side → Side trim on tunnel side, removing and installing .

• Remove backrest → Front seat backrest, assembly overview .
• Disconnect heated seat connector -3-.
• Pinch off clips - 2  - (2x).
• Pry out piping at rear - 4  -.

• Pry out surround piping - 5  -.
• Remove cover and padding - 1  -.
• On vehicles with ISOFIX holder and new cover fabric - 1  - , cut slots in fabric cover at location of ISOFIX holder.

2 - Clips (2x)

3 - Heated seat connector

4 - Rear piping

5 - Surround piping