Rollover protection, assembly overview: Notes
1 - Rollover protection
- Removing
- Remove rear bench seat → Rear seat bench, assembly overview .
- Remove rear seat backrest → Rear seat backrest, assembly overview .
- Remove trim for ski bag → Removing and installing trim for through-load bag .
- Close convertible top and fold convertible top compartment upward.
- Unclip clips - 3 - (2x) on back panel trim - 2 -.
- Fold back panel trim - 2 - aside in direction of - arrow -.
2 - Luggage compartment back panel trim
3 - Clips (2x)
1 - Rollover bar
- Remove bolts - 2 - (2x).
- Fold convertible top compartment downward.
2 - Bolts (2x)
1 - Rollover protection
- Actuate convertible top far enough to allow access to convertible top compartment.
- Extend rollover protection - 1 - Refer to guided fault-finding, body, general body repairs, 01 systems with self-diagnosis capability, Airbag 8.4E, Functions-Airbag 8.4E J234-Airbag Control Module, output DTM.
- Unclip clips - 3 - (2x) on back panel trim - 2 -.
- Fold back panel trim - 2 - aside in direction of arrow.
2 - Luggage compartment back panel trim
3 - Clips (2x)
1 - Rollover protection
- Check if and where shims are installed on rollover protection - 1 -.
- Mark the points where the shims were removed.
- Remove bolts - 2 - (4x).
2 - Bolts (4x)
1 - Rollover protection
- Press catch - 3 - and detach connector for solenoid valve - 2 -.
- Pull out rollover protection - 1 -.
- Installing
- If installed, install shims in same places on rollover protection - 1 -.
- Retract rollover protection - 1 - Retracting rollover protection .
- Ensure that connector for solenoid valve - 2 - engages audibly.
- Install rollover protection - 1 - in reverse order of removal.
- Check function of rollover protection with control element test. Refer to guided fault-finding, body, general body repairs, 01 systems with self-diagnosis capability, Airbag 8.4E, Functions-Airbag 8.4E J234-Airbag Control Module, output DTM.
2 - Connector for solenoid valve
3 - Release