Rear Final Drive 0BR/0BS/0BY, Gear Oil, Checking
Special tools and workshop equipment required
- Torque Wrench 5-50 NmV.A.G 1331
- Charging Device F/Haldex 2 Coup. VAS 6291
- Drip Tray for VAS 6100 VAS 6208
Test Requirement
- The vehicle must be horizontal.
Oil Level, Checking
-- Place VAS 6208 under final drive.
-- Remove the bolt -1-.
The oil level is correct when the rear final drive is filled up to the lower edge of the filler hole.
-- Screw in the bolt -1- and tighten.
Tightening Specification: 15 Nm
Oil, Filling:
-- Add enough oil using the VAS 6291 until it runs out between the filler tool adapter and the transmission housing.
-- Remove the filler tool and adapter; a little oil left over will run out.
The oil level is correct when the rear final drive is filled up to the lower edge of the filler hole.
-- Screw in the bolt -1- and tighten.
Tightening Specification: 15 Nm