Rear Final Drive 0BR/0BS/0BY, Gear Oil, Checking

Special tools and workshop equipment required 

• Torque Wrench 5-50 NmV.A.G 1331
• Charging Device F/Haldex 2 Coup. VAS 6291
• Drip Tray for VAS 6100 VAS 6208

Test Requirement 

• The vehicle must be horizontal.

Oil Level, Checking 

-- Place VAS 6208 under final drive.

-- Remove the bolt -1-.

The oil level is correct when the rear final drive is filled up to the lower edge of the filler hole.

-- Screw in the bolt -1- and tighten.

Tightening Specification: 15 Nm

Oil, Filling: 

-- Add enough oil using the VAS 6291 until it runs out between the filler tool adapter and the transmission housing.

-- Remove the filler tool and adapter; a little oil left over will run out.

The oil level is correct when the rear final drive is filled up to the lower edge of the filler hole.

-- Screw in the bolt -1- and tighten.

Tightening Specification: 15 Nm