Erase DTC memory
NOTE:
If it is not possible to erase the DTC memory, check the DTC memory again and repair any DTCs that may exist.
Prerequisites
- DTC memory checked
- All DTCs repaired.
After DTC memory has been successfully checked:
Performing function 05 - "Erase DTC memory"
| Rapid data transfer HELP Select function XX |
Indicated on display
- Press buttons -0- and -5-.
| Rapid data transfer Q 05 - Erase DTC memory |
Indicated on display
- Confirm input with -Q- button.
| Rapid data transfer → DTC memory is erased! |
Indicated on display
The DTC memory is now erased.
- Press → button.
| Rapid data transfer HELP Select function XX |
Indicated on display
NOTE:
- This message indicates an error in the test sequence:
- This message indicates an error in the test sequence:
Adhere exactly to test sequence: first check DTC memory, if necessary repair DTCs, then erase.
After erasing DTC memory carry out function 06 "End Output" then switch ignition off and on again and check DTC memory again.