High mount brake light - Coupe, removing and installing

CAUTION:

Before beginning repairs on the electrical system:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Removing

NOTE:

Do not operate brake pedal.
In the event of a malfunctioning LED, the complete high-mount brake light assembly must be replaced.

Open rear lid and unclip/remove tray.

Fig 1: High Mount Brake Light Assembly And Electrical Connection

GW00017079

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Slide high mount brake light assembly -2- forward and remove from rear window. If necessary, gently lever the assembly out on the left and right edges using a screwdriver.
Pull electrical connection out from retainer clip.
Disconnect electrical connection -1-.

Installing

Install in reverse order of removal.
Ensure electrical connection is securely located in retainer.
Confirm brake light function.