Headlights with High Intensity Gas Discharge (HID) Lamps, assembly
WARNING:
- HIGH VOLTAGE!
- Always disconnect negative ( - ) battery terminal prior to servicing any parts of the HID lamp system marked with the yellow "HIGH VOLTAGE!" symbol.
- After disconnecting battery, briefly turn headlights on and off in order discharge any residual voltage.
NOTE:
- After performing any repairs or service that could affect headlight aim, check/adjust aim. Refer to .Halogen headlights, adjusting . See also: 01 MAINTENANCE .
- Headlights with HID lamps are equipped with automatic vertical headlight aim control system. Refer to General information .
1 - Headlight housing
- Lense bonded to housing, cannot be replaced separately.
- From approx. 04.00, High Intensity Gas Discharge Lamp Control Modules -J343- and -J344 are mounted directly to housing.
- Removing and installing. Refer to Headlight housing, removing and installing .
2 - Fog Light bulb -L22-/-L23
- H3 - 12 V, 55 W
- Replacing. Refer to Fog light bulbs, replacing
3 - Parking/side marker light bulb -M1-/-M3-
- H6 - 12 V, 6 W
- Replacing. Refer to Parking/side marker light bulb, replacing
4 - High Beam Headlight bulb -M30-/-M32-
- H7 - 12 V, 55 W
- Replacing. Refer to Halogen high beam bulb, replacing
5 - High beam and parking/side marker light bulb holder
6 - Cover (small)
7 - Cover (large)
8 - Turn signal bulb holder
9 - Front Turn Signal Light bulb -M5-/-M7-
- H21 - 12 V, 21 W
- Replacing. Refer to Turn signal bulb, replacing
10 - Securing ring (bayonet connection) for HID bulb
11 - HID bulb -L13-/-L14-
- 35 W, D2S
- Replacing. Refer to HID bulb, replacing