Automatic vertical headlight aim control system, layout
WARNING:
- HIGH VOLTAGE!
- Always disconnect negative ( - ) battery terminal prior to servicing any parts of the HID lamp system marked with the yellow "HIGH VOLTAGE!"symbol.
- After disconnecting battery, briefly turn headlights on and off in order discharge any residual voltage.
1 - Headlights with High Intensity Gas Discharge (HID) Lamps
- With Headlight Beam Adjusting Motors -V48- & -V49-
- Removing and installing. Refer to Headlight housing, removing and installing .
2 - Left Front Level Control System Sensor -G78-
- Located at left front control arm of front axle
- Removing and installing. Refer to Left Front Level Control System Sensor -G78-, removing and installing
3 - Left rear level control system sensor -G76-
- Front-wheel drive: located at rear axle
- Removing and installing. Refer to Left Rear Level Control System Sensor -G76-, removing and installing
- All-wheel drive: located at rear crossmember left
- Removing and installing. Refer to Left Rear Level Control System Sensor -G76-, removing and installing
4 - Headlight Range Control Module -J431-
- Coupe: located below rear seat bench
- Removing and installing. Refer to Headlight Range Control Module -J431- - Coupe, removing and installing
- Roadster: located behind bulkhead, center, below convertible top storage compartment, on floor
- Removing and installing. Refer to Headlight Range Control Module -J431- - Roadster, removing and installing