Instrument cluster, removing and installing: Removing
NOTE:
- Instrument cluster must not be disassembled.
- It is not necessary to remove the steering wheel. For ease of illustration the steering wheel is not shown in the following illustrations.
- All removed cable ties are to be re-attached in same position on installation.
CAUTION:
Before beginning repairs on the electrical system
- Switch off all electrical consumers.
- Switch off ignition and remove ignition key.
- Use adjuster to pull out and pivot steering wheel downwards as far as possible.
- Remove driver's storage compartment.
Refer to 68 - INTERIOR EQUIPMENT
- Remove screws -1-.
- Pull out instrument cluster from bottom in order to disengage upper mounting clips.
- Pry off clips from rear of instrument cluster using 80-200.
- Release cable ties on rear of instrument cluster.
- Release retainer catches in direction of -arrow- and disconnect electrical connections from instrument cluster.