LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2005 >> TT Base, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Electrical Equipment >> 01 On Board Diagnostic (OBD) >> Instrument cluster through m.y. 2000 - VIN 8N_Y040000 and software version D24, On Board Diagnostic (OBD) >> Adaptation (function 10) >> Odometer, adaptation

Odometer, adaptation

This function is used to set the correct odometer reading after replacing the instrument cluster.

Preparation 

NOTE:
  • The adaptation function can only be performed on instrument clusters with a maximum of 100 kilometers or 63 miles indicated on counter.
  • The adaptation procedure can only be performed once on any one instrument cluster.
  • The adaptation value entered must be higher than the existing value (over 100 kilometers or 63 miles).
  • If an incorrect value is entered and confirmed, it cannot be changed. In this case the instrument cluster must be replaced.
scientia non olet · About LEMON Manuals