Center Defroster Outlet, Removing and Installing

Special tools, testers and auxiliary items required 

Fig 1: Trim Removal Wedge 3409

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Trim removal wedge 3409
• Feeler gauge

Fig 2: Prying Out Sunlight Photo Sensor G107 And Disconnecting Harness Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

• Unclip cover cap - 1  - using a feeler gauge 0.35 mm - 2  - out of center defroster vent - arrow  -.
• Pry out Sunlight Photo Sensor G107 - item 3  - and disconnect harness connector.

Fig 3: Prying Center Defroster Vent Out Of Instrument Panel Using Trim Removal Wedge 3409

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolt - 1  -.
• As depicted in the illustration, pry center defroster vent - 2  - out of instrument panel using trim removal wedge 3409.

Installing 

Installation is reverse of removal.

Tightening torque:

Center defroster vent to instrument panel: 2 Nm