LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2005 >> A8 Quattro >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (6.0L - Fuel Injection And Ignition, Engine Code(S): BSB) >> 24 Fuel injection system >> Oxygen sensors, servicing >> Heated Oxygen Sensor (HO2S) -G39- (before catalytic converter, right front), removing and installing >> Installing

Heated Oxygen Sensor (HO2S) -G39- (before catalytic converter, right front), removing and installing: Installing

WARNING: This page is about a different variant/trim than selected.

Perform installation in the reverse order of removal, noting the following:

NOTE:
  • New oxygen sensors are coated with assembly paste; the paste must not get into slots on the oxygen sensor body.
  • When re-installing a used oxygen sensor, coat the threads with hot bolt paste. This paste must not come into contact with slots on oxygen sensor body.
  • During installation, all cable ties must be re-installed at the same location.
  • Wires of oxygen sensors must always be secured in the same position when installing so that contact with the exhaust pipe is avoided.
scientia non olet · About LEMON Manuals