Right exhaust manifold with catalytic converters, removing and installing: Removing

WARNING: This page is about a different variant/trim than selected.

Engine/transmission assembly removed and attached to scissor lift platform VAS 6131.

NOTE:

All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.

Fig 1: Oxygen Sensors Electrical Harness Connectors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

4 - Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) G130 , (4-pin, black)

5 - Oxygen Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) G131 , (4-pin, brown)

7 - Heated Oxygen Sensor (HO2S) 2 G108 , (6-pin, brown)

8 - Heated Oxygen Sensor (HO2S) G39 , (6-pin, black)

NOTE:

Fig 2: Pivot Bracket Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts - arrows - and pivot bracket for right exhaust manifolds with catalytic converters downward.

Fig 3: Right Exhaust Manifold Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove nuts - 1 to 4 - and remove right exhaust manifold with catalytic converters.