Upper coolant pipe, removing and installing: Installing

WARNING: This page is about a different variant/trim than selected.

Installation is in reverse order of removal. Note the following:

NOTE:

Replace seals and O-rings.
Secure all hose connections using hose clamps appropriate for the model type .
During installation, all cable ties must be reinstalled at the same location.

Install strut tower brace → 40 - FRONT SUSPENSION .
Install and adjust wiper arms → 92 - WINDSHIELD WIPER AND WASHER SYSTEM .
Install intake manifold lower part: → Intake Manifold Lower Section, Removing and Installing .
Install intake manifold upper part: → Intake Manifold Upper Section, Removing and Installing .

Fill with coolant → Filling under Cooling System, Draining and Filling