Front final drive, checking gear oil level

WARNING: This page is about a different car, the 2010 Audi A8, 2009 Audi A8, 2008 Audi A8, 2007 Audi A8, and 2004 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Drip Tray V.A.G 1306

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drip tray V.A.G 1306
Safety glasses

Test condition

Gear oil temperature at approx. 20° C (room temperature).

Test sequence

To ensure vehicle is absolutely level, drive onto a 4-column lifting platform or over a service pit.
Place drip tray V.A.G 1306 underneath transmission.

CAUTION: Wear eye protection.

Fig 2: Inspection Plug

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove inspection plug - arrow -.

The fluid level must be at the bottom edge of inspection hole opening.

Drain off excess gear oil or top off to proper level; Specification → Capacities .

NOTE:

Sealing plug with sealing ring must be replaced.

Tighten new sealing plug to 35 Nm.