Selector lever handle, removing and installing

WARNING: This page is about a different car, the 2010 Audi A8, 2009 Audi A8, 2008 Audi A8, 2007 Audi A8, and 2004 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Place selector lever in position "D".

Fig 1: Selector Lever Handle, Removing/Installing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Rotate sleeve - 1 - clockwise until it engages. Slide sleeve down in this position.
Remove handle - 2 - from selector lever.

Installing

Installation is in reverse order of removal, note the following:

Place selector lever in position "D".
Place sleeve - 1 - on selector lever.
Press handle - 2 - onto selector lever as far as stop.

Installation position: Button facing driver.

Slide sleeve up while rotating until tabs on sleeve engage in slits on handle.
Rotate sleeve counter-clockwise until it engages.