Check DTC memory
NOTE:
The displayed malfunction information is not constantly up-dated but only when initiating the On Board Diagnostic (OBD) or with the function 05 "Erase DTC memory."
- Switch on printer with the Print button (indicator lamp in button lights up).
Performing function 02 - "Check DTC memory"
| Rapid data transfer HELP Select function XX |
Indicated on display
- Press buttons -0- and -2-.
| Rapid data transfer Q 02 - Check DTC memory |
Indicated on display
- Confirm input with -Q- button.
| X DTCs recognized! → |
The number of DTCs stored will appear on the display.
The stored DTCs are displayed and printed out one after the other.
- Check printout against DTC table and repair all malfunctions as necessary. Refer to DTC table .
| No DTC recognized! → |
If the message "No DTC recognized" is displayed the program can be returned to the starting point by pressing the → button.
| Rapid data transfer HELP Select function XX |
Indicated on display
If something else is displayed:
Refer to Scan tool operating instructions
- Erase DTC memory (function 05). Refer to Erase DTC memory .
- End output (function 06). Refer to End output .
- Switch off ignition and disconnect diagnostic equipment.