Wiper blade park position, setting
- Briefly operate wiper motor and allow it to return to park position.
- Check if wiper blades rest against marking -1- on windshield
- Check dimensions -a- and -b-.
Specifications:
- a = 25 + 5 mm
- b = 35 + 5 mm
NOTE:
Dimensions given here are the minimum distances between the ends of the wiper blades and the plenum cover at the bottom edge of the windshield.
If specifications not met
- Remove wiper arms. Refer to Windshield wiper system, removing and installing .
- Align wiper arms to meet specification and tighten nuts to 16 Nm.
Tightening torque
| Component | Nm |
| Wiper arm to wiper shaft | 16 |