Headlight Range Control Module -J431- - Coupe, removing and installing
Removing
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove rear seat bench.
Refer to 72 - SEAT - FRAMES
- Release clips -arrows-.
- Remove module -2- from bracket -3-.
- Disconnect electrical connection -1-.
Installing
Install in reverse order of removal, noting the following:
OBD function - "Basic setting" must be performed on -J431- when replacing
Refer to VAS 5051/5052 in operating mode "Guided Fault Finding".