Driver Side Electronics Box, Removing and Installing

• Component location: On vehicle floor beneath drivers seat.

Removing 

• Remove drivers seat → 72 - SEAT - FRAMES .
• Switch off ignition and remove ignition key.
• Remove lower A-pillar trim → 70 - INTERIOR TRIM .
• Fold back floor carpet.

Fig 1: Drivers Side Electronics Box Cover Latches

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Release cover for drivers side electronics box - arrows  - and fold to side.

Fig 2: Removing Control Modules Out Of Drivers Side Electronics Box

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove control modules - 1  - out of drivers side electronics box - 2  -.
• Take out electronics box.

Installing 

Install in reverse order of removal, observing the following:

• Install lower A-pillar trim → 70 - INTERIOR TRIM .
• Install drivers seat → 72 - SEAT - FRAMES .