Ultrasonic interior monitoring, On Board Diagnostic (OBD): Adaptation
The adaptation function can be used to carry out and store the following adjustment:
- The ultrasonic sensors can be adjusted to reduce their sensitivity level.
Performing adaptation (function 10)
| Rapid data transfer HELP Select function XX |
Indicated on display
- Press buttons -1- and -0-.
| Rapid data transfer Q 10 - Adaptation |
Indicated on display
- Confirm input with -Q- button.
| Adaptation Feed in channel number XX |
Indicated on display
- Press buttons -0- and -1-.
| Adaptation Q Channel display 10 |
Indicated on display
- Confirm input with -Q- button.
| Channel 1 Adaptation 100 → Sensitivity in % < - 1 3- > |
Indicated on display: the display will show the sensitivity level of the sensors, e.g. 100%.
NOTE:
The max. sensitivity level for the ultrasonic sensors is 100% (factory setting). This can be reduced down as far as 50%.
- Press → button.
| Channel 1 Adaptation 100 Enter adaptation value XXXXX |
Indicated on display
- Enter sensitivity level e.g. 75 % = 00075
| Channel 1 Adaptation 100 Q Enter adaptation value 00075 |
Indicated on display
- Confirm input with -Q- button.
| Channel 1 Adaptation 75 Q Sensitivity in % (- 1 3- > |
Indicated on display
- Confirm input with -Q- button.
| Channel 1 Adaptation 75 Q Store changed value? |
Indicated on display
- Confirm input with -Q- button.
| Channel 1 Adaptation 75 → Changed value is stored |
Indicated on display
- Press → button to terminate adaptation procedure for sensitivity level.
| Rapid data transfer HELP Enter address word XX |
Indicated on display