Fog light bulbs, replacing
Removing
Vehicles with HID headlights:
CAUTION:
Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Disconnect negative ( - ) battery terminal.
- When reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in this article. Refer to Battery, disconnecting and reconnecting .
WARNING:
- HIGH VOLTAGE!
- Always disconnect negative ( - ) battery terminal prior to servicing any parts of the HID lamp system marked with the yellow "HIGH VOLTAGE!"symbol.
- After disconnecting battery, briefly turn headlights on and off in order discharge any residual voltage.
Removing
Vehicles with halogen headlights:
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
Left headlight:
- Remove battery if necessary. Refer to Battery, removing and installing .
- Remove cover -arrows-.
Right headlight:
- Remove screw -1- and remove cover over expansion tank -arrow-.
Both sides (continued):
- Remove cover -1- by turning counter-clockwise -arrow-.
- Disengage spring clip -2- and remove bulb -1- from housing.
- Disconnect electrical connection -3-.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- Insert new bulb in housing.
- Note bulb installation position
- Secure bulb with spring clip.
- Reconnect electrical connection and close housing cover.
- Reinstall battery if necessary. Refer to Battery, removing and installing .
- Adjust fog lights. Refer to Fog lights, adjusting .