LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2003 >> TT Base, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Electrical Equipment >> 01 On Board Diagnostic (OBD) >> Automatic vertical headlight aim control system, On Board Diagnostic (OBD) >> Diagnostic Trouble Code (DTC) table

Diagnostic Trouble Code (DTC) table

NOTE:
  • All possible malfunctions recognized by the automatic vertical headlight aim control system and printed out by the VAG1551 Scan Tool (ST) are listed on the following sections according to the 5-digit DTC.
  • The 5-digit DTC numbers are only shown on the printout.
  • Before replacing a component suspected of malfunctioning, check all related wiring connections, harness connections and Ground (GND) connections according to the appropriate wiring diagram. Refer to "Wiring Diagrams, Troubleshooting & Component Locations" binder.
  • After completing necessary repairs, connect the VAG1551 scan tool, check DTC memory (scan tool function 02) and, if necessary, erase DTC memory (scan tool function 05).
  • DTC memory contains all static and sporadic faults. A malfunction is recognized as static if it exists for at least 2 seconds. If a static malfunction is no longer present after 2 seconds it will be classified as a sporadic malfunction and identified by the letters "/SP" in the lower right of the VAG1551 scan tool display.
  • When the ignition is switched on, all malfunctions present are identified as "sporadic" and are only stored as static malfunctions if they are detected in the next check routine.
  • A sporadic malfunction will be erased if it no longer exists after 50 driving cycles (ignition on for at least 5 minutes, road speed above 30 km/h or 18 mph).
DTC  Possible causes  Corrective action 
VAG 1551 Scan Tool display     
00625     
Vehicle Speed Signal    
  • Implausible signal
  • Open circuit or short circuit between instrument cluster and control module.
  • Check wiring for open circuit or short circuit according to wiring diagram.
00774     
Level Control System Sensor, LR-G76    
  • Short circuit to B+
  • Open circuit or short circuit between left rear level control system sensor -G76- and control module
  • Check wiring for open circuit or short circuit according to wiring diagram.
  • Open/short circuit to Ground
  • -G76- faulty
  • Replace -G76-.
00776     
Level Control System Sensor, LF-G78    
  • Short circuit to B+
  • Open circuit or short circuit between left front level control system sensor -G78- and control module
  • Check wiring for open, short circuit according to wiring diagram.
  • Open/short circuit to Ground
  • -G78- faulty
  • Replace -G78-.
DTC  Possible causes  Corrective action 
VAG 1551 Scan Tool display     
01537     
Sender for Veh. Level/Supp. Volt.    
  • Short circuit to B+
  • Open circuit or short circuit to B+/Ground between control module and vehicle level sensor
  • Check wiring for open circuit or short circuit according to wiring diagram.
  • Open/short circuit to Ground
   
01538     
Motors for Beam Adjustment-V48/V49    
  • Short circuit to B+
  • Short circuit to B+/Ground between left headlight beam adjusting motor -V48-, right headlight beam adjusting motor -V49- and control module
  • Check wiring for open circuit or, short circuit according to wiring diagram.
  • Short circuit to Ground
  • -V48-, -V49- faulty
  • Replace -V48-, -V49-.
01539     
Headlights Not Set
  • Basic setting 2 (in display group 002) not performed
65535     
Control Module Malfunctioning
  • Automatic vertical headlight aim control system control module -J431- faulty
  • Replace control module.