Micro central electric and 13-position relay panel, removing and installing

CAUTION:

Before beginning repairs on the electrical system:

Obtain the anti-theft radio security code.
Switch off all electrical consumers.
Switch ignition off and remove ignition key.
Disconnect negative ( - ) battery terminal.

When reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in this article. Refer to Battery, disconnecting and reconnecting .

Removing

NOTE: All removed cable ties are to be replaced and attached in original location.

Disconnect battery. Refer to Battery, disconnecting and reconnecting .
Remove driver's lower instrument panel trim

Refer to 68 - INTERIOR EQUIPMENT

Fig 1: Relay Panel And Components

GW00017136

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws -C-. If necessary, remove all terminal connections -D- and -E-.
Remove relays and control modules.
Unclip appropriate relay carrier.
Remove central electric and 13-position relay panel downwards.

NOTE:

Fig 2: Starting Interlock Relay -J207-

GW00015824

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Individual terminal and relay assignments

Refer to Wiring Diagrams and/or COmponent Locations

NOTE:

Fig 3: Identifying Fuel Pump (FP) Relay J17

GW00008303

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Individual terminal and relay assignments

Refer to Wiring Diagrams and/or COmponent Locations

Installing

Install in reverse order of removal, noting the following:

NOTE: All removed cable ties are to be replaced and attached in original location.

Reconnect battery. Refer to Battery, disconnecting and reconnecting .

Tightening torque

Component	Nm
Central electric/relay panel to mounting	2