Fuse panel, removing and installing

CAUTION:

Before beginning repairs on the electrical system:

Obtain the anti-theft radio security code.
Switch off all electrical consumers.
Switch ignition off and remove ignition key.
Disconnect negative ( - ) battery terminal.

When reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in this article. Refer to Battery, disconnecting and reconnecting .

Removing

NOTE: All removed cable ties are to be replaced and attached in original location.

Disconnect battery. Refer to Battery, disconnecting and reconnecting .
Remove driver's lower instrument panel trim

Refer to 68 - INTERIOR EQUIPMENT

Fig 1: Identifying Fuse Holder, Screws & Locking Tab

GW00004264

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws -B-.
Release clips -C- and push fuse panel behind and below instrument panel.

Fig 2: Fuse Panel Cover And Cable Tie

GW00017134

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Cut cable tie -1-.
Release cover -arrows-.
Remove fuses.

Fig 3: Removing Retaining Strip For Connectors

GW00017135

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove retaining strip for connectors -arrows-.
Remove connectors.
Unclip socket -1-.

NOTE:

Fig 4: Identifying Main Fuse Panel

GW00000097

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Individual fuse assignments

Refer to Wiring Diagrams and/or Component Locations

Installing

Install in reverse order of removal of removal, noting the following:

NOTE: All removed cable ties are to be replaced and attached in original location.

Reconnect battery. Refer to Battery, disconnecting and reconnecting .

Tightening torque

Component	Nm
Fuse box to instrument panel central tube	3