Auxiliary relay panel in left rear engine compartment, removing and installing
CAUTION:
Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Disconnect negative ( - ) battery terminal.
- When reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in this article. Refer to Battery, disconnecting and reconnecting .
Relay panel is located on left of engine compartment in front of bulkhead
Removing
- Disconnect battery. Refer to Battery, disconnecting and reconnecting .
- Disconnect electrical connection -1- at air-mass meter.
- Release tab -3- in direction of arrow and disengage relay carrier upwards at bulkhead.
- Release clips -2-, -4- and -5- and remove cover.
NOTE:
Individual connector and terminal assignments
Refer to Wiring Diagrams and/or Component Locations
Installing
Install in reverse order of removal, noting the following:
- Reconnect battery. Refer to Battery, disconnecting and reconnecting .