Headlight Range Control Module -J431- - Roadster, removing and installing
Removing
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove rear side panel trim
Refer to 70 - INTERIOR TRIM
- Release nuts -arrows-.
- Remove module -1-.
- Disconnect electrical connection -1-.
Installing
Install in reverse order of removal, noting the following:
OBD function - "Basic setting" must be performed on -J431- when replacing
Refer to VAS 5051/5052 in operating mode "Guided Fault Finding".
Tightening torques
| Component | Nm |
| Control module to body | 2.5 |