Diagnostic Trouble Code (DTC) Memory, erasing
NOTE:
If it is not possible to erase the DTC memory, check the DTC memory once again and repair malfunctions.
Requirements
- DTC memory checked. Refer to Diagnostic Trouble Code (DTC) Memory, checking (function 02)
- All malfunctions repaired
After DTC memory has been successfully checked:
| Rapid data transfer HELP Select function XX |
Indicated on display:
- Press buttons -0- and -5- to select "Erase DTC Memory" function 05.
| Rapid data transfer Q 05 Erase DTC Memory |
Indicated on display:
- Press -Q- button to confirm input
| Rapid data transfer → DTC memory is erased! |
Indicated on display:
The DTC memory is now erased.
- Press → button.
| Rapid data transfer HELP Select function XX |
Indicated on display:
NOTE:
- This message indicates an error in the test sequence:
- This message indicates an error in the test sequence:
Adhere exactly to test sequence: First check DTC memory, if necessary repair malfunctions, then erase.