SID: Maximum time interval, adaptation
This function stipulates a max. time interval in days for the SID.
| Rapid data transfer HELP Select function XX |
Indicated on display:
- Press buttons -1- and -0- and confirm input with Q button.
| Rapid data transfer Q 10 - Adaptation |
Indicated on display:
- Press-Q- button to confirm input.
| Adaptation Enter channel no. XX |
Indicated on display:
- Press buttons -4- and -4- to access "channel 44".
- Press-Q- button to confirm input.
- Indicated on display: Display shows maximum time interval in days until the next service (here, e.g. 730 = 730 days).
NOTE:
- The value entered for the corresponding engine variation must correspond to value of table. Refer to General information .
- Confirm maintenance intervals applicable to vehicle. Refer to Service Circulars, Maintenance.
- The respective specified value can only be entered in steps of single days and the display is therefore also in days.
- When using the button pad on the scan tool, the number must be entered directly.
- If an incorrect value is entered adaptation function will be terminated and must be restarted.
- Press → button.
- Indicated on display:
- Required value via scan tool button pad, filling in the initial spaces with "0".
Input value: e.g. 730 days
Entry via keypad: 00730
- Indicated on display:
- Press-Q- button to confirm input.
- Indicated on display:
- Press-Q- button to confirm input.
- Indicated on display:
- Press-Q- button to confirm input.
- Indicated on display:
- Press → button to terminate adaptation of maximum time interval.