Replacement instrument cluster input values, adapting

It is important to note the following points when replacing the instrument cluster:

NOTE:

The instrument cluster must always be coded.
Before replacing the existing instrument cluster, record odometer reading and values appearing in all service interval display adaptation channels.
Recorded values must be adapted to new instrument cluster so it can count down to the next service due.
The immobilizer control module is integrated in the instrument cluster. Immobilizer function adaptation is also necessary after replacing instrument cluster.

The following steps must be carried out after replacing the instrument cluster:

Code instrument cluster. Refer to Code Control Module (function 07) .
Service Interval Display (SID): entering distance remaining until next Inspection Service. Refer to Adaptation (function 10) .
SID: entering time remaining until next Inspection Service. Refer to Adaptation (function 10) .
Adapt odometer reading. Refer to Adaptation (function 10) .