Diagnostic Trouble Code (DTC) Memory, checking (function 02)
NOTE:
The displayed diagnostic information is not constantly up-dated, but only when starting the On Board Diagnostic (OBD) or with the function 05 "Erase DTC Memory."
- Switch on printer with the Print button (indicator lamp in button lights up).
| Rapid data transfer HELP Select function XX |
Indicated on display:
- Press buttons -0- and -2- to select "Check DTC Memory" function 02.
| Rapid data transfer Q 02 - Check DTC Memory |
Indicated on display:
- Press -Q- button to confirm input
| X DTCs recognized! |
The number of stored DTCs appears in the display.
The stored DTCs are displayed and printed out one after the other.
- Check printout against DTC table and repair all malfunctions as necessary. Refer to Diagnostic Trouble Code (DTC) table .
| No DTC recognized! → |
If "No DTC recognized" is displayed the program will return to the start point after pressing → button.
| Rapid data transfer HELP Select function XX |
Indicated on display:
If something else is displayed:
Refer to Scan tool operating instructions
- End Output (function 06). Refer to End Output (function 06) .
- Switch off ignition and disconnect data link connector.